ASME B5.62M:2016 pdf free download

ASME B5.62M:2016 pdf free download
ASME B5.62M:2016 pdf free download.Hollow Taper Tooling With Flange-Face Contact
Form B. Like Form A, Form B is for use on machine tools with automatic tool changers, but it has a reduced taper compared to Form A. Keyways are located on the flange. Form B includes provision for through-flange coolant and manual tool change. See Figure 1-1.3-1, illus- tration (b).
1-2 FORMS A AND C
Form Aincludes provisions forautomatic tool change, a data chip, an orientation notch, an access hole for manual clamping, drive keyways, and through-spindle coolant supply via coolant tube. Form C is intended for manual tool change and includes an access hole for manual clamping, drive keyways, and through-spindle coolant supply.
1-3 FORMS B AND D
Forms B and D include provisions for a data chip, an orientation notch, an access hole for manual clamping, drive keyways, and through-spindle coolant supply. Figures 1-3-1 and 1-3-2 and Table 1-3-1 show the geometry and dimensions of HSK Forms B and D.
1-4 FORM E
Form E includes provisions for through-spindle coolant supply and automatic tool change. Form E does not include provisions for a data chip, an orientation notch, an access hole for manual clamping, or drive keyways. Figure 1-4-1 and Table 1-4-1 show the geometry and dimensions of HSK Form E.
1-5 FORM F
Form F includes provisions for through-spindle coolant supply and automatic tool change. Form F does not include provisions for a data chip, an orientation notch, an access hole for manual clamping, or drive keyways.
Figure 1-5-1 and Table 1-5-1 show the geometry and dimensions of HSK Form F.
1-6 FORM T
Form T includes provisions forautomatic tool change, a data chip, an orientation notch, an access hole for manual clamping, drive keyways, and through-spindle coolant supply via coolant tube.
Figure 1-6-1 and Table 1-6-1 show the geometry and dimensions of HSK Form T.
1-7 IDENTIFICATION CODING
Figure 1-7-1 shows the identification coding format for HSK shanks. As shown in Table 1-7-1, not all possible combinations of nominal size and feature are allowed per this Standard.